In the majority of situations, most individuals spend quite a bit of money buying their lift truck. Thus, it is extremely essential to take proper care of it so as to protect your investment well into the long run. It is really a great idea to know the procedures which are undertaken during the care and maintenance of this piece of machinery.
Amongst the best ways to tell how good the engine is running is by starting the lift truck up and listening closely to see how it runs. Like for example, if there are any misses or knocks, the machine is defective and this should raise several concerns. Moreover listen closely for any squealing sounds which come from the belts as these sounds would provide you with a wealth of information.
When performing maintenance, several of the main parts you will have to pay attention to consist of the horn, safety warning devices, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also vital to check the wiring.
The battery compartment terminals must be cleaned after the above components have been inspected carefully. If the terminals are not clean, be sure to clean them well. Every cell of the battery has to be inspected so as to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters must be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be done. If there is a grease fitting on the axle make sure to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Then, check every other part of the machine including the wheels. If any type of fault or problem is detected, be certain to address it immediately so as to make sure the machinery is running at its safest and optimum levels.